Edge-lighting Soft Strip Cove Square System Manual de usuario

Busca en linea o descarga Manual de usuario para Encendiendo Edge-lighting Soft Strip Cove Square System. Edge Lighting Soft Strip Cove Square System User Manual Manual de usuario

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 2
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 0
Installation Instructions for Soft Strip Cove
904-SCO-01
Install the Soft Strip Cove
1
1718 W. Fullerton Ave
Chicago, IL 60614
Tel: 773-770-1195
Fax: 773-935-5613
www.edgelighting.com
© 2012 Edge Lighting. All Rights Reserved.
SAVE THESE INSTRUCTIONS!
- This instruction shows a typical installation.
IMPORTANT INFORMATION
SCO-_
0.62"
2.5"
0.5"
0.28"
Soft Strip Cove Dimensions
A
WALL
1: Mark the key hole locations of the Soft Strip Cove on a
straight line where the Soft Strip Cove is going to be
installed.
NOTE: Two people are required if the Soft Strip Cove is used as a
template to mark the installation holes.
NOTE: Prior to Soft Strip Cove installation the low voltage wires
should be present. Refer to the instructions provided with the
power supply to install the low voltage wires before proceeding
with the steps below.
SOFT STRIP COVE
LOW VOLTAGE
WIRE
MOUNTING
HOLE
1
1
B
2: Tap the anchors onto the marked points up to the threaded
portion with a hammer.
3: Screw in the threaded portion of the anchors with a Phillips
screwdriver.
WALL
2
3
ANCHOR
NOTE:
mounting the Soft Strip Cove to a wood surface directly.
Steps 2 to 3 are for drywall mounting. Omit these steps if
Vista de pagina 0
1 2

Indice de contenidos

Pagina 1 - Soft Strip Cove

Installation Instructions for Soft Strip Cove 904-SCO-01Install the Soft Strip Cove11718 W. Fullerton AveChicago, IL 60614Tel: 773-770-1195Fax: 773-93

Pagina 2

2DWALL5: Feed the power wire into the Soft Strip Cove conduit hole.6: Hang the Soft Strip Cove keyholes onto the exposed screws.7: Tighten the #8 scre

Comentarios a estos manuales

Sin comentarios