Edge-lighting Light Channel Trim 1.6 Manual de usuario descargar pdf

Installation Instructions for Light Channel Trim 1.6

1718 W. Fullerton Ave

Chicago, IL 60614

Tel: 773-770-1195

Fax: 773-935-5613

www.edgelighting.com

[email protected]

SAVE THESE INSTRUCTIONS!

IMPORTANT INFORMATION

904-LCT-1_6_02

LCT1.6-5WDC-_

junction box (mounts to any side of the housing

depending on the orientation of the channel) and secure

them with the mounting brackets and two Phillips screws

provided.

: Mount each adjustable mounting bar to one side of the

- This fixture is wall or ceiling mount.

- This instruction shows a typical installation.

- If modifying channel length, please see “Section

Three: Modifying Channel Length” on Page 4 before

installation.

JUNCTION

BOX

JUNCTION

BOX

MOUNTING

BRACKET

ADJUSTABLE

MOUNTING BAR

PHILLIPS

SCREW

VERTICAL

ORIENTATION

HORIZONTAL

ORIENTATION

Section One: Installing The Channel

NOTE: The adjustable mounting bars mount to studs that are

spaced 13" to 24" apart.

2: Select the location between the two studs for the junction

box to be mounted.

3: Place the adjustable mounting bars between the studs.

4: Make sure the lips on the adjustable mounting bars are

against the studs. Secure the adjustable bars to the studs

with the eight #8 screws.

JUNCTION

BOX

ADJUSTABLE

MOUNTING BAR

STUD

#8 SCREW

STUD

ADJUSTABLE

MOUNTING BAR

CONDUIT

JUNCTION BOX

5: Remove a knockout to install the power line conduit.

6: Install the conduit and run the low voltage 24V DC power

wires coming from the remote power supply to the

junction box.

7: Refer to the instruction provided with the power supply

along with the wiring diagram for proper wiring.

1 2 3 4

Light Channel Trim 1.6 1

Indice de contenidos

Pagina 1 - Light Channel Trim 1.6

Installation Instructions for Light Channel Trim 1.61718 W. Fullerton AveChicago, IL 60614Tel: 773-770-1195Fax: 773-935-5613www.edgelighting.cominfo@e

Pagina 2

DRYWALL2.25"LENGTH OF THE CHANNELDREMEL MULTI-MAXD6" FIXEDJAB SAW8: Mark the area where the channel will be located on the drywall.9: Cut ou

Pagina 3

317: Push the male connector of the Soft Strip into the female connector of the power connector.18: Carefully remove the backing from the LED soft str

Pagina 4

1: Mark the wall where channel mounting holes are located along the channel opening.2: Cut 1" thick by 3" long sections of 2x4 to use as sup

Comentarios a estos manuales

Sin comentarios

Edge-lighting Light Channel Trim 1.6 Manual de usuario

Busca en linea o descarga Manual de usuario para Encendiendo Edge-lighting Light Channel Trim 1.6. Edge Lighting Light Channel Trim 1.6 User Manual Manual de usuario

Indice de contenidos

Comentarios a estos manuales

Relacionado con productos y manuales para Encendiendo Edge-lighting Light Channel Trim 1.6