Edge-lighting Fast Jack 26 Port Canopies Without Transformers Manual de usuario

Busca en linea o descarga Manual de usuario para Encendiendo Edge-lighting Fast Jack 26 Port Canopies Without Transformers. Edge Lighting Fast Jack 26 Port Canopies Without Transformers User Manual Manual de usuario

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 2
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 0
SAVE THESE INSTRUCTIONS!
FJC-24SQ-_
Installation Instructions for 24" Square 20 & 26 Port Fast Jack
Canopy Only
904-FJC-24SQ-01
IMPORTANT INFORMATION
1718 W. Fullerton Ave
Chicago, IL 60614
Tel: 773-770-1195
Fax: 773-935-5613
www.edgelighting.com
© 2012 Edge Lighting. All Rights Reserved.
1
Running the Power from a Remote Transformer to the
Fast Jack Canopy
A
1: Run the low voltage wires from a remote transformer to
electrical box where Fast Jack canopy is going to be
installed. It is recommended to install the remote
transformer near the electrical box to avoid voltage drop.
Refer to the instructions provided with remote transformer
for low voltage wire size chart. Refer to the low voltage wire
size chart provided with the remote transformer.
REMOTE
TRANSFORMER
ELECTRICAL BOX
CONDUIT
MAX
20FT
FAST JACK
CANOPY
1
- This product is ETL listed for indoor dry locations.
Install the Canopy
B
MOUNTING PLATE
CANOPY
#8-32 SCREW
1
1
1: Remove the sixteen #8-32 screws around the canopy to
remove the mounting plate.
C
MOUNTING PLATE
#8-32 SCREW
3
2
3
2: Feed the low voltage coming from the remote transformer
through mounting plate center hole.
3: Align the mounting plate slots with the electrical box holes
and secure it to the electrical box holes with the provided
two #8-32 screws.
NOTE: It is recommended that a person to hold the mounting
plate while the electrician installs it.
Vista de pagina 0
1 2

Indice de contenidos

Pagina 1 - Canopy Only

SAVE THESE INSTRUCTIONS!FJC-24SQ-_Installation Instructions for 24" Square 20 & 26 Port Fast Jack Canopy Only904-FJC-24SQ-01IMPORTANT INFORMA

Pagina 2

4: Tap the anchors through the mounting plate holes onto the marked point up to the threaded portion with a hammer.5: Screw in the threaded portio

Comentarios a estos manuales

Sin comentarios