Edge-lighting Step Manual de usuario descargar pdf

HOUSING

WING NUT

Installation Instructions for Step Halogen Kit

904-STEP-KIT-H-02

1718 W. Fullerton Ave

Chicago, IL 60614

Tel: 773-770-1195

Fax: 773-935-5613

www.edgelighting.com

[email protected]

Install the Step Housing

1: Loosen the two top and bottom wing nuts on the housing to

remove the two mounting brackets.

STEP-KIT-H1M_

STEP-KIT-H1S_

MOUNTING BRACKET

THREADED STUD

HOUSING LIP

WING NUT

MOUNTING

BRACKET

THREADED STUD

2: Mount one adjustable mounting bar to the top of the housing

by sliding it completely under the housing lip.

3: Replace the mounting bracket onto the threaded studs so

that the flange faces the adjustable mounting bar. Tighten

the wing nuts to secure the adjustable mounting bar in

place.

4: Repeat steps 2 and 3 for the bottom of the housing.

MOUNTING

BRACKET

FLANGE

ADJUSTABLE

MOUNTING BAR

SAVE THESE INSTRUCTIONS!

- This product is ETL listed for indoor dry locations.

- This product is wall mounted only.

- This product can be dimmed with a electronic low voltage

dimmer.

IMPORTANT INFORMATION

IMPORTANT SAFETY INSTRUCTIONS

To reduce the risk of fire, electrical shock, exposure to

excessive UV radiation, or injury to persons:

- Use this fixture indoors only.

- Do not look directly at the lamp while the fixture is on.

- RISK OF FIRE: Use only the type of lamp and maximum

wattage indicated in this instruction manual.

- Never cover the halogen lamp with anything other than a

lamp shield provided by Edge Lighting and never place

flammable material close to the fixture.

- Never turn the fixture on and off by connecting and

disconnecting the halogen lamp.

- Do not touch the fixture head, shade or lamp shield while

the fixture is on. These surfaces may be VERY HOT.

- Do not touch lamp at anytime. Use a soft cloth instead as oil

from skin may damage lamp.

- It is normal for a new halogen lamp to produce minor

smoke when first turned on.

- Turn power off and allow to cool before replacing lamp.

LOW VOLTAGE WIRE SIZE CHART

TRANSFORMER

WATTAGE

WIRE SIZE

FOR 10 FT

WIRE SIZE

FOR 11-15 FT

WIRE SIZE

FOR 16-25 FT

WIRE SIZE

FOR 26-40 FT

75 WATT #14 GA #12 GA #10 GA #8 GA

1 2 3 4

Indice de contenidos

Pagina 1

AHOUSINGWING NUT_Installation Instructions for Step Halogen Kit904-STEP-KIT-H-021718 W. Fullerton AveChicago, IL 60614Tel: 773-770-1195Fax: 773-935-56

Pagina 2

D9 9: Loosen the four #8-32 screws on the front of the housing. 10: Remove the trim and cover from the housing.TRIM9COVER#8-32 SCREW1011: Remove a

Pagina 3 - STEP WIRING DIAGRAM

3Slave Step Kit WiringF1: Run the proper low voltage wires to each housing by referring to the "Low Voltage Wire Size Chart" on page 1. The

Pagina 4

G12: Feed the pigtail wires through the cover hole and mount to cover to the housing with the four #8-32 screws.13: Repeat step 12 for the remai

Comentarios a estos manuales

Sin comentarios

Edge-lighting Step Manual de usuario

Busca en linea o descarga Manual de usuario para Encendiendo Edge-lighting Step. Edge Lighting Step User Manual [en] Manual de usuario

Indice de contenidos

Comentarios a estos manuales

Relacionado con productos y manuales para Encendiendo Edge-lighting Step