Edge-lighting Alice Mirror LED - Dimmable Manual de usuario

Busca en linea o descarga Manual de usuario para Para Casa Edge-lighting Alice Mirror LED - Dimmable. Edge Lighting Alice Mirror LED - Dimmable User Manual Manual de usuario

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 2
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 0
Installation Instructions for Alice LED
904-ALICE-28-LED-02
1718 W. Fullerton Ave
Chicago, IL 60614
Tel: 773-770-1195
Fax: 773-935-5613
www.edgelighting.com
Install the Mounting Plate
1
ALICE-28-LED
© 2014 Edge Lighting. All Rights Reserved.
A
1: Loosen and remove the four M6 screws on the top and
bottom of the mounting plate with the 3mm Allen wrench.
2: Pull the mounting plate completely out of the mirror.
SAVE THESE INSTRUCTIONS!
- This product is wall mounted only.
- Supply power to mirror in accordance with local electrical
codes.
- This instruction shows a typical installation.
- This product is dimmable with ELV dimmers.
- Ensure that power to the junction box is turned OFF
before beginning any electrical work.
IMPORTANT INFORMATION
NOTE: It is recommended that more than one person install this
product.
B
M6 SCREW
MIRROR
MOUNTING
PLATE
1
2
3: Align the mounting plate hole with the power line conduit or
junction box. Use the mounting plate as a template to
mark four mounting holes (highlighted in GREEN) onto the
wall.
NOTE: Make sure that the mounting plate is leveled horizontally.
ALIGN CENTER WITH
JUNCTION BOX
MOUNTING
HOLE
3
3
4: Tap the anchors onto the marked points up to the threaded
portion with a hammer.
5: Screw in the threaded portion of the anchors with a Phillips
screwdriver.
ANCHOR
ANCHOR MUST
BE FLUSH TO WALL
H
WALL
4
5
Vista de pagina 0
1 2

Indice de contenidos

Pagina 1 - Alice LED

Installation Instructions for Alice LED 904-ALICE-28-LED-021718 W. Fullerton AveChicago, IL 60614Tel: 773-770-1195Fax: 773-935-5613www.edgelighting.co

Pagina 2

26: Feed the 120 VAC power wires through the mounting plate.7: Line up the mounting plate holes with the anchors and secure it with the four #8-32

Comentarios a estos manuales

Sin comentarios